Website

Terms of use

1. General
These webpages were compiled by Singleplast Wilfred Single GmbH and are the latter's property. The contents of the website are protected under applicable international copyright and trademark treaties. Singleplast Wilfred Single GmbH reserves the right to be able to delete, modify or amend these pages for any reason whatsoever at any time and without prior notice. This shall also apply to the contents of these terms of use.


2. References and links
In case of references of any kind to external webpages that lie outside our scope of responsibility, a liability obligation would only arise in the event that the author had knowledge of the contents and it were technically possible and reasonable for him to prevent use in case of illegal contents. We hereby expressly declare that at the time of link insertion, no illegal contents were noticeable on the pages to which the links were to be made. The author does not have any influence whatsoever on the current and future layout, contents or copyrights.


3. Copyright and trademark law
Singleplast Wilfred Single GmbH endeavours to observe all copyrights of the texts, graphics, video sequences and sound documents. An attempt is made to resort to texts, graphics, video sequences and sound documents compiled ourselves. All the brand names and trademarks mentioned within the website and possibly protected by third-party rights are unlimitedly subject to provisions of the respective proprietor. Copyright for published objects produced by the author himself remains solely with the author of the page. Reproduction of texts, graphics, video sequences and sound documents in other electronic or printed publications is not allowed without the author's express consent.
 

 

Thermoforming

The products are just as varied as the requirements. Our products are used in the car/commercial vehicle industry, electronics industry, furniture manufacture, medical engineering and domestic and air conditioning technology in addition to other areas.


Injection moulding

We produce injection moulded components based on your drawings or also using the tools that you provide. High quality technical plastics such as PC, POM and PA are moulded in addition to the conventional standard thermoplastics, such as PS, ABS, PP and PE.

Use of cookies

In order to optimize our website for you and to be able to continuously improve it, we use cookies. By continuing to use the website, you agree to the use of cookies. For more information about cookies, please visit our Privacy.